Neutrarust Instructions for use

Neutrarust 661® – is a water based non-hazardous rust converter that is simply painted onto rust and acts as a high quality primer.

 

Stir well before use. Do not dilute

Remove flaky rust, loose scale and dirt with thorough wire brushing. Reduce any high peaks of rust. Remove acid, alkali, grease oil and chemicals with detergent water wash then rinse surface with cold water. Paintwork blistered by rust should be scraped down to hard surface. IMPORTANT – DO NOT REMOVE ALL TRACES OF HARD RUST. These areas must be adequately covered with Neutrarust 661®

Before use. pour into non metallic container to avoid the transfer of rust particles into original container. Do not pour unused portion back into original container.

Apply 2 or 3 coats of Neutrarust 661® by brush, spray or roller. Cross brush for best results. Rust will turn to black. It can dry to a high gloss finish, it may be necessary to lightly abrade to provide a ‘key’ for subsequent paint coatings. Being water-based, Neutrarust 661® adsorbs any surface moisture during its curing process and the strong resin forms a seal.

During application of Neutrarust 661® it changes colour from off white to blue to black. At the blue stage continue gently brushing for a further 2 minutes and allow to dry for the chemical reaction. Surplus Neutrarust 661® may cause staining of surrounding paintwork if allowed to dry. Remove surplus immediately.

Neutrarust 661® is self priming and will accept most paints. Leave 24-72 hours or longer to dry hard before applying undercoat or top coats of paint. When applying light coloured topcoats  i.e. white, yellow, blue, pink etc. Ensure that correct under colour (1 or 2 coats) is applied.

TEMPERATURE RANGE, USE & STORAGE    

Neutrarust 661® should not be applied to cold metal below 5°C or hot metal above 40°C. But will withstand temperatures between -40°C and 60°C when dried hard. Store between  5°C and 35°C. Not to be used or stored outside of recommended temperatures.  Replace cap after use. Use in adequately ventilated area. Do not store in direct sunlight.

P280: wear protective gloves & eye protection

DRYING TIMES – Each Coat Touch dry—summer approx. 20 minutes, winter approx. 45 minutes. Between coats: summer and winter approx. 2 hours. Protect from rain during drying

CLEANING BRUSHES OR SPILLAGE Use detergent water wash and rinse with water or industrial solvents.

Neutrarust 661® MUST NOT BE SWALLOWED If swallowed, wash out mouth with water and give water to drink. Harmful by inhalation treat symptomatically. Eyes: splashes to the eye should be removed by washing with eyewash solution or water for at least 10 minutes. Skin: splashes should be washed off with water and soap as soon as possible. If in any doubt as to effectiveness of any treatment, obtain medical attention immediately.

KEEP OUT OF REACH OF CHILDREN. SLIGHT IRRITANT

Classified non-hazardous, non-combustible & dry film is fire retardant

CONDITIONS OF SALE – Since we have no control over the working conditions, different materials involved and the circumstances under which the purchaser stores, handles or uses this material, we make no warranty or condition, either express or implied, with respect to this material.

EUH210: Safety data sheet available on request

 

Neutrarust 661® your hallmark of the original product. BEWARE of COPIES

 

Neutrarust 661® Registered   Trademark of and produced by Neutra Rust Europe Ltd